RJ45 Repair / Réparation RJ45

Repairing the RJ45 clip

Here is an accessory that allows the use of an RJ45 plug whose clip is broken.

The shorter does not require support for printing.

The longest need a support for printing, compatible with rigid cables of 6mm.

After printing the accessory, rotate the square end as shown in the picture. This is to create the blocking of the plug, clipping the accessory on the cable so that the square comes to rest on the plug in the place of broken tab.

Layer thickness 0.1 to 0.3

Hull thickness 1

Fill rate 25

Temperature of 220C ° printing

Media Type none

---

Repair of the RJ45 clip

Here are two accessories that allow the use of an RJ45 plug with a broken clip.

The shorter one doesn't need any support at the print.

The longest needs a support to the printing, compatible with rigid cables of 6mm.

After printing the accessory, rotate the square end as shown in the photo. This is to create the blocking of the plug, clip the accessory on the cable so that the square comes to rest on the plug in place of broken leg.

Layer thickness 0.1 to 0.3

Hull thickness 1

Filling rate 25

Printing temperature 220C°.

Media type none