Electronic Surface/Height Gauge

An add-on to your electronic caliper (fits most standard calipers). 2 version of calipers width

• up to 16mm width
• up to 17mm width

The gauge can be used to Router and Table Saw.

This is of course NOT a high precision solution, but it is quite flat and does its job within a 0.05mm error range.

###Assembly and Use

The hole is 3.5 mm diameter, so you can screw in a M4 bolt/screw without the need to cut a thread.

• Insert the caliper and fix it with a screw.
• If necessary, install a heel on the caliper probe.
• Place the gauge on a smooth, flat surface.
• Lower the caliper probe until it touches the base surface.
• Zero the caliper. Now when you lift the probe, the height will be displayed (as a negative value)

See also:
Mechanical Surface/Height Gauge
Surface Gauge