ITX SMALL FORM FACTOR Commodore 64 COMPUTER CASE - Commode 64 bit

Commodore 64 ITX case. The Commode 64 bit

---

The case parts should ideally be printed from heat resistant material but warping must be avoided. I used PLA though and insulated the inside with foam tape and aluminum tape.

The prototype was printed with an earlier revision of the files and I have not test printed everything. If anything's wrong write a comment in the comment field on the bottom of this page.

---

Recommended parts:
Programmable macro keypad: https://ebay.us/Bsfy14
SVIVE Tritium 60% mechanical keyboard
Mean Well EPP-200 12 V power supply
160 W PicoPSU
USB3 extension for the right side (or USB2 if needed): https://ebay.us/8iEzxU
40x40 mm fan for the left side near PSU.
6x6 mm tactile buttons for the right IO: https://ebay.us/6FyD3T
Red 5mm led for the power light: https://ebay.us/l4HIJs
USB header adapter for internal connection of the keyboards (or just cut and wire a new connector yourself): https://www.ebay.com/itm/393835443674

---

Badge01.stl - Badge that looks like the original C64 badge.
Badge02.stl - Commode 64 Bit badge.
Badge01.stl - Power light badge.
Bottom02-left.stl - Bottom half.
Bottom03-right.stl - Bottom half.
Feet01.stl - Plastic part that is glued to the bottom case.
Feet02.stl - Rubber part that fits inside Feet01.
Fkeys01.stl - Base for the underside of the macro keypad.
Fkeys02.stl - Function keys with centered cherry base.
Fkeys03.stl - Function keys with offset cherry base.
IO-01.stl - Right side IO with XT60 panel mount, power button and USB.
IO-02.stl - Right side IO with XT60 male plug mount, power button and USB.
IO-03.stl - Right side IO with barrel power plug, power button and USB.
IO-04.stl - Right side IO with reset button, power button and USB.
Keyb01.stl - Cradle for 60% keyboard.
Keyb02.stl - Cradle for 60% keyboard with tabs on the edges.
Tab01.stl - Tabs for the rear of the case for mounting the top to the bottom half.
Top02-left.stl - Top half.
Top03-right.stl - Top half.