Micro Camera Gimbal Test Print

This is a free test and calibration print for Micro Calibration Gimbal.
See: https://cults3d.com/en/3d-model/gadget/micro-camera-gimbal-ysoldak

This is 3-piece fitting test, a gear and two plates.
Print to see if gear teeth come out nicely for you. Also, you can verify servo connector and camera cable go w/o problems though the gear.

Fit the gear into Pan Top part, it shall rotate freely, but no wobble.
The gear must, with little force, snap into Tilt Base part. Fix these two parts together with two short M2 screws.
Check for side-to-side wobble.

The assembly shall function as a simple fidget spinner you can gift a kid, if everything works as expected 😃

Pan Large part is separate and to test compatibility with servo shaft. It accepts 4.85mm diameter shaft with 21 teeth/splines.
Such servos are MG90S and Savöx.