PS5 Dualsense Stand + USB charger

With your PS5, you had a USB cable.

I designed this stand around it.

So this stand for the Dualsense controller will charge it!

It is very easy to print and assemble, you don't need support.

There are only 2 parts needed (left and right).

The 2 side panels are for decoration (3 or 4 layers thick).

The front cover with PS logo is optional. I printed it, and in the middle of the progression, I faked an end of filament so the printer asked me to change it. This is how I did the bicolor thing.

The cylinders (printed in orange) are finally not needed because the USB cable will guide the 2 parts correctly, but I include the stl...

I used super glue to assemble everything.

The side covers are printed flat. To deform them you can warm your printer bed at 70°, let the side cover for a couple of seconds on it, and it will become flexible enough to match the shape of the stand.

Even if I measured the original cable, other ones should work too.

---

Hello !

With your PS5 you got a USB cable.

The object is created based on it.

There are only 2 parts needed to print (left and right hull)

The two side panels are decorations (3 or 4 layers thick)

The logo on the front is also optional. I started printing it and in the middle I faked a filament end. The printer asked me to change it and that's how I was able to do the two-color printing.

the orange-printed cylinders are optional, but I put the stl.

I used super glue to put it all together.

The side panels are printed flat. To deform them, you can reheat your printer bed to 70°, leave the panels on for a few seconds to soften them. You then press them against the shell so that they fit the shape as they cool down.

Even if the measurements were made with the original sony cable, other cables will work without problems.