Comet-Captain Flam

to make the reactors rotatable take a 3mm diameter threaded rod, cross the cockpit and screw it into the mid_tunnel-1_1 bearing. tap this part beforehand.

inner axle is used to lock the 10x3x4 bearings (ext, int, width) through and inside mid_hyperrotatif, axle ring is used to set the operating clearance inside or outside mid_hyperrotatif, sphere front plug is used to hide the threaded rod hole and nut.

front and rear reactor addition

front support offset is used to offset the front support, which itself holds the cockpit in place so that it doesn't rotate.

to turn the reactors take a threaded rod diam 3mm, cross the cockpit and go screw it in mid_tunnel-1_1 bearing. tapping this piece before

inner shaft is used to lock the bearing 10x3x4 (ext, int, width) through and inside mid_hyperrotatif, ring axis is used to adjust the operating clearance inside or outside the mid_hyperrotatif, plug front sphere serves to hide the hole and the nut of the threaded rod.

adding reactor front and rear

front support offset is used to deport the front support which allows itself to hold the cockpit in place so that it does not rotate