Print In Place Magnetic Heart Locket Fidget Toy

Boost MeBoosting helps this model become more visible to other users and gives me more motivation to create more designs for you guys!

Commercial license for all my models -→ https://www.patreon.com/MeasureOnce

PLEASE READ BEFORE PRINTING

This project requires 10 4x2mm magnets.Please see the BOM for the link to makersupplies to purchase them. The joints should feel loose without the magnets. Once you install them, the magnets will stabilize the joints and the spinning improves significantly.

FOLLOW THE STEPS BELOW TO PROPERLY GET THE JOINTS FREE

STEP 1: After printing, wait 5-10 minutes for the plastic to cool down and fully harden before twisting. After 10 minutes. twist along the crease as shown in gif below. 

STEP 2: MAKE SURE YOUR PART HAS COOLED BEFORE DOING THIS STEP. Keep the locket in the heart position and place your thumb on the bottom of the heart. Gently work free the 2nd joint by spinning the half about your thumb as shown in the gif below. Spin one direction for a little than the other. Once one side starts spinning freely, spin it a full 360. 

STEP 3: Glue 10 4x2 magnets in the locations shown in the image below. Be mindful of their polarity.