Hueforge | JDM Drift Car 100/150/200mm

Description

JDM Drift Car Inspired 4 Color Swap Hueforge 3D Portrait

-Pair with My HueFrame Here https://makerworld.com/en/models/137722#profileId-149895 Make sure to Download the 3mm Depth frame to match this print.

Specs:

-100x100mm, 3mm Depth, 3mm Border Width

• 5mm Brim included with print profile Recommended

-150x150mm, 3mm Depth, 3mm Border Width

• 8mm Brim included with print profile Recommended

-200x200mm, 3mm Depth, 3mm Border Width

• 10mm Brim included with print profile Recommended

-Sparse Infill Rectilinear

-100% Infill

-.20 Layer Height

-Filament swap Instructions:
    -Start with Black
    -Change color at layer #5 Silver
    -Change color at layer #7 Gold
    -Change color at layer #11 White

Take A Look:

-As always Double check your settings, print profile and printer selection to this print profile as this is based off of the X1 Carbon and Frostbite build plate. I like to run hotter print temps which might not be correct for your setup.

Material and Recommendations:

-Recommend using Bambu Lab Basic PLA if your enviroment (away from Direct sunlight) allows, for faster print times.

-Recommend Speeds below 100mm/s if possible with Generic PETG, Highest print quality aroung 75mm/s. Printing temp 250-260c

-If printing with Bambu Lab PETG HF use recommend settings on filament roll. Printing temp 245-260c

-Recommend higher temps with PETG to decrease print time,

-Recommend printing with a Brim to keep corners secure to build plate.

-Recommend Glue stick to assist in keeping corners from warping