1/64 Loadout Grain Auger

The loadout Auger file is out and AVAILABLE NOW :) 

This project took a bit for me to be happy with as I had gone through different prototypes of materials to use for a straight and consistent tubing material but that would also be realistic size reference. 

 

This is a good way to use any damaged arrow shafts, and you can cut it down to size. 

 

Sizing is based relativly on a 10" Auger. You can determine your length you would like by however long you cut the fiberglass Arrowshaft.

 

https://a.co/d/467vS4i

 

 

 * Note: Not all brands of 6.2mm Arrow shafts have the exact same outer diameter. Consider printing in 1 color first if using different brand of arrow shafts.

 

* Be careful when removing supports from the bottom flightiong section so yoouiu dont crush the caging.

Boost MePlease consider Boosting Me! More designs in prototype currently :)

 

You can choose to paint it to match but with the design and being able to slide, it's meant to have some friction to hold its position and you can change the pitch between transport and loading into higher trailers, grain carts, and smaller bins.

 

Also you can use either M1.4x5mm screws or M1.7x6mm for the wheels. Tighten till they get stiff and then back off until they spin freely.

 

Belt is just a small elastic band. Should be able to use a kids braces elastics as well if you have any kicking around.

 

Please rate and post your designs