January 25, 2025
Description
After a few attempts, I found that the best method to clean the lead screws is with a dishwashing sponge.
Cloths fiber and leave residue that can settle in the lead screw bearing, so this method should not be used.
In order to clean the lead screw with the sponge, I created these pliers. In this way, there is a very high probability that, on the one hand, the lead screw will be cleaned very well and, on the other hand, there will be no risk of damage to the bearing.
Needed Tools: None!
Assembling: The pliers do not need to be assembled because the joint is "print in place". Take a dishwashing sponge and cut two small, matching pieces. Press the sponge pieces into the pockets provided.
Using the lead screw cleaner: Move the print bed all the way down. Wet the contact surface of the sponges with a little isopropyl alcohol. Place the pliers on the lead screw and carefully move the print bed upwards step by step, always keeping the pliers closed. Keep enough distance from the upper stop, otherwise injuries and damage can occur! Every now and then, check the condition of the sponge and remove any residue on the sponge.
Repeat these steps a few times until no residue is visible and you are satisfied with the result.
Recommended filament: PLA+
Hotend: 0,40mm
Print instructions for PLA (my print profile is set up like this):
Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.
Bad build plate adhesion is not related to the model.
Take a look at my other models https://makerworld.com/en/u/1597610120
Please leave me a like and a decent rating if you were satisfied, thank you in advance!
Boost MePlease consider boosting my model if you are satisfied.
License:
Standard Digital File License
SaVo3D
