Propane Tank Support v1

This is an older version of my Propane Tank model, see the new version here:
https://makerworld.com/en/models/1963192-propane-tank-support-v2#profileId-2110357

I modeled this to help raise my propane tank in up and allow my Mopeka Tank Sensor to have room an not hit the ground.

There are 3 sizes included. 1.5, 2.0, 2.5 mm which is referring to the tension nubs in the groove for the tank foot.  I had 4 tanks and i found even the same model tanks seem to vary a little so I just referenced these.

I used PETG and ABS to print these.  If you want a 1 size fits all, I would recommend perhaps using the 2.0 mm and use TPU.