Sy's Peglock pegboard disposable glove box holder

Pegboard mount that holds a box of disposable gloves.  Includes both right and left side pieces that can hold disposable glove boxes in either the vertical or horizontal position.   This glove box holder was designed around the brand of disposable gloves I commonly use.  In order to fit in BOTH the horizontal and vertical positions, the maximum glove box size it can accommodate is 9.5" (241.3mm) x 4.5" (114.3mm) x 2.625" (66.675).  If your box is slightly larger, it may still be able to fit in either the vertical OR horizontal orientation as only two of the three maximum measurements are critical for either orientation.

This disposable glove box holder is designed for pegboards with 1-inch (25.4 mm) hole spacing commonly sold in US hardware stores. Designed around Sy's Peglock System, both the pegboard holder and pegboard clips can be printed flat and without supports.  This eliminates the weak pegs that are prone to breaking in other pegboard models because the print orientation is not optimal for the strength of the hooks, which are much stronger when the plane of the hook is parallel to the print bed.  

The build plate includes two pegs for the typical 0.25-inch (6.35 mm) thick "Home Depot" pegboard with 0.25-inch holes.  While pegboards in the US have a standard 1" hole spacing, the actual boards can be a range of thicknesses and hole sizes.  So sizing hooks to fit the thickest boards, results in a loose-fitting hook on the thinner-boards.   You can generate different sized pegs from this Onshape project.

Printing:  I printed in both PLA and PETG with the standard 0.20 mm settings

Assembly:

To mount, fold each "peglock pegboard clip" with the flat printed sides together.  Insert it into the pegboard so the triangular surfaces point up spaced to match the slots on the rack, then slide the rack down over top.  It should securely fit into place compressing the rack against the board and preventing accidental movement.

Additional Pegboard Organizers:

Links for other styles of pegboard organizers I have created can be found here:  Pegboard Organization for pegboards with 1" hole spacing.