Console Table

This is a fully 3D-printed console table.  Featuring an elegant traditional design that is sturdy enough to withstand jumping cats and rambunctious grandchildren.  Standing 30-3/4 inches (781mm) tall, it is suitable for use as an accent table, a small entrance way table, or as a light worktable. 

The legs are assembled by screwing the pieces together. 

The leg assemblies are connected to the side, front, and back panels using 3mm x 10mm self-tapping screws.

The tabletop pieces are connected to the center brace and then to the leg supports using 3mm x 10mm self-tapping screws. 

The strength of the table is due to an internal structure in the legs.  In the center of the legs is a 13mm hole that runs most of the length of the legs.  Printed as is, the legs seem to be strong enough but if one desires an even stronger table, a 27-inch long ½ inch wooden dowel can be inserted into the hole in the center of the legs.  It will be a tight fit but if more than light tapping is required, the dowel should be sanded down a bit. 

Filaments

For the legs I used Bambu brown galaxy because it looks a bit like mahogany and the Bambu basic PLA basic gold for the top because it goes well with the brown galaxy. 

48  3mm x 10mm self-tapping screws Bambu Lab part number BT3X10 - AA200