Modular Hexagon Frame for 130mm Tile Prints Skadis

I designed these frames for the excellent 130mm Pokemon Huforge Hexagon tiles that I printed from another user (Sebastien), I wanted a way to mount them all either on my Ikea Skadis boards or with a screw on a wall, but make it modular so I could use as many of the tiles as I wanted in a set.

There are 3 corners built into the main back frame to hold the printed hex tile on which will let you slide the tile in, then push the 4th triangular piece to the left of the frame to hold it in, it should be a nice snug fit but you may need to scale up a tiny bit depending on your printers tolerances. 

Same goes for the connectors, they should be nice an snug fit and pop in place but your printer may vary, but these are small pieces so easy to adjust in your slicer as you need and print again so not much wasted filament to get a nice fit to the frames.

Print as many or few of the link plates or ikea peg board mounts as you need.

They should all clip together and create a nice mosaic. If you are doing a big wall piece I recommend a dab of glue on the connectors to make sure it does not come apart, hanging a couple together should be ok without.

You should not need any supports on this even for the link overhangs, they have printed fine for me on my A1/A1 mini without any supports.

Any feedback on the design or things you think could change to make it better let me know!