Self Balancing Zapdos! Multipart printing!

To start, you need to know this model is a little tricky to print!

 

The model is 350mm wide, scaling down is difficult because of the size of the eyes.

 

The 3mf bambu file, contains the needed tweaks to make it work, basically:

 

1 - XY Hole compensation of 0,15

2 - XY contour compensation of -0,10

3 - Brim on pieces that have low contact area.

4 - Modifier Cube on Main Wing, to change the infill %, and adjust the CG (Center of Gravity). This may vary between filament brands and types of plastic.

 

*To print the Beak and the Eyes, a you need only a 1 color change, so you don't need an AMS.

*Just use some Super Glue after you printed, and let it dry.

 

Boost MeIf you liked this design, give a Boost!

 

Yes, i ran out of yellow mid print, and would take another week to refill =/