Needed a good toilet paper dispenser, but could not find one here on maker world. Found one by OspreyGozo over on Thingaverse and thought i would share it here. Have devided it in top, bottom and middle as well as black and white.
Will paste in what he said in the description here:
"This is an upgrade over my older model https://www.thingiverse.com/thing:3136805
This one is sturdier, uses dovetail joints and, depending on your printer's calibration, might not need glue for the parts to fit together. If you really need to use glue, super glue will do. The holder can be mounted to a wall using 3 screws.
The model is printed in parts to make it easier to print and to take advantage of orientation for strength. The parts are already oriented and have a chamfer at the bottom to counter elephant foot (which could make fitting the parts harder)."
Somewhat assembly instructions:
TOP SECTION
- Place top left/right down on the table
- Connect the top front and back piece to the top left/right piece and make sure the flat sides are facing the same direction.
- Now put some glue into the connecting joint.
- Proceed with immediately slotting in the remaining piece to ensure a perfect square hole and dab some glue into the joints.
MIDDLE SECTION
- Place the middle left/right side down as you join it with the dovetail from the top assembly. Dab it with some glue to secure it.
- Make sure where you put the last back piece (the one with screw holes in it) and place the middle back piece. Put some glue on all dovetail joints to secure it.
- Put the middle front piece (middle piece with a flat side) on, making sure the flat part is facing down the z-axis of the model and secure it with glue.
- Secure the middle assembly with the last middle side piece and glue it in place
BOTTOM SECTION
- Put the whole assembly on the backside.
- Slot in the Bottom back piece (the last one with screw holes) in its place and secure it with glue.
- Slot the Bottom piece in the bottom back piece as you make sure the flat side is sticking up. Now secure it with glue.
- Slide on the bottom right and left part and secure with glue.
Now you have your very own toilet paper dispenser :D
Inofaith
