A1 mini enclosure (with plexi)

I've released an updated version of this design. Please check it out!

(click photo)

 

 

Made this enclosure for my A1 mini since it sits inside a garage which gets dusty. The model uses plexi panels, so it comes with an additional costs, but I found it worth since it looks a bit cleaner and has the option to swap when something is broken - no huge printing. This was all printed with basic PLA.

 

I had 3 sizes for the panels. One for the sides, one for the front and one for the door. Below you find the measurements.

• Thickness of the plexi panels: 3mm
• 4x Side panels: 50 x 50 cm (500 x 500mm)
• 1x Front panel: 50 x 50 cm (500 x 500mm) with a 35 x 35 cm (350 x 350 mm) cut out with an offset on the X-axis of 25 cm (250 mm) and Y-axis 22,5 cm (225 mm)

• 1x Door: 30 x 30 cm (300 x 300mm)

   

Assembly 

• Print all the pieces you need / want
• Put everything in place and mark the holes
• Use an 3mm drill to make the holes. ! Use something underneath and don't use a lot a force since it can break !
• Remount the pieces and use screws and nuts (M3) to assemble.
  • The pieces on both sides of the plexi: M3 x 12
  • The pieces only on the front: M3 x 10

 

I used a total of 73 screws and nuts

Screws

• M3 x 12: 66
• M3 x 10: 7

Nuts

• M3: 73
   

I mounted the 2 handles and side holders in the center and that's something you will need to measure yourself. Same for the position of the door holder and lock.

 

Boost MeI'm trying my best :'(