RIGHT/LEFT Spool holder with guide X1C,P1S,X1E

New version of side filament spool holders with filament guide for bambulab printers, designed to fit on the side of X1C, P1S and X1E printers.

• No any other hardware needed.
• It is designed for printing without support.
• It can be printed with PLA, PETG, ASA, ABS…

The holder has two versions, the version for the left side of the printer (when viewed from the front of the printer) and the version for the right side of the printer.

Instructions for right side spool holder:

1. Filament Holder is designed to fit on the right side of the printer, and there is no need to use any external accessories. To attach the new holder, unscrew the screws from the original location. The screw position is shown in the figure below.

    2.  Once we have two screws from the original location, we can move to the right side of the printer (when viewed from the front). Here it is necessary to unscrew the short screw at the corner of the printer. Subsequently, a new holder can be attached with screws, which we have obtained from the original location to the holes shown in the photo below. Note: Screwing longer screws into these holes may go more difficult for the first time.

     3.  In the following step, it is necessary to fix the filament guide to the filament holder. Filament guide is slid into the holder and attached with a short screw that remains from the previous step. The mounted Filament Guide is shown in the following figure.

      4. In the last step, PTFE tube is inserted into the prepared hole at the Filament Guide as shown the image below. If PTFE tube is very loose in Filament Guide, you can use a drop of superglue.

Instructions for left side spool holder:

1. The assembly procedure of the left side spool holder is very similar to the above. The holder is mounted in the holes of the original spool holder with original screws, that are shown in the figure below.

     2. To attach the Filament Guide in Spool Holder it is necessary to use a single M3 screw of a maximum length of 8 mm or you can use black short screw from the original bag “For extruder” which comes with the printer.

     3. In the last step, PTFE tube is inserted into the prepared hole at the Filament Guide as shown the image below. If PTFE tube is very loose in Filament Guide, you can use a drop of superglue.

Congratulations, that's all. You have successfully made and installed a new filament holder V2.0. I will be very happy for every support of my models !