Leaperkim Lynx Charger Seat

Don't carry your heavy charger, add it to your wheel!

Great for long trips with lots of charging or for daily riding with quick and easy charging. Plug and play!

Works to charge your wheel in-place without removing the charger or even the power cable. Though extending the XT-90 to GX-5 cable slightly may be needed to have both plugs work, as I did.

Works to charge your wheel in-place without removing it (Though extending your charger cable slightly may be needed to have both plugs work)

Please. Please:

Take a photo and post it as a make. It's what brings me joy.

Show our community gives a flying fuk about designers. Hit ♡, take a photo.

Also see this design on printables!

Charger compatibility

• Made for the V4SC. (~42mm height, ~104mm wide, 272mm long)
• Other chargers are easy to add, please request it in my → discord ←

Parts

• lynx seat - seat body.stl is the main body
  •  ~160g of TPU
• lynx seat - seat back.stl is the seat extension. Clips in to the body nicely.
  • ~40g of TPU
• r4830 - front V4SC logo-all by t4obrien.stl is from my bumper design.
  • ~22g of TPU each, 2 recommended (one for each side)

Printing

• For printing in TPU only. 95A recommended.
• Print as-oriented in the STL. 
• No supports needed for any part.
• Infil: 10%
  • Adaptive Cubic is best
  • Gyroid for extra squishiness
• 2 Walls is plenty

Mounting

• Secured with velcro “Hook and Loop Tape”. I used a minimal amount of this [amazon]
• Also optionally secured with a strap through the slot on the top (see photos)
  • Not really needed if you use a lot of velcro on top.
  • Great if you don't! I used some old webbing and added velcro to the ends.

Licence

Direct personal non-commercial use only. No redistribution. Please only share this design page.

Are you Roger and want to sell this design as if you made it as well? No is the nicest thing I can say.