instax mini film fridge magnet

Instax Mini Fridge Magnet

This is a simple print with no supports needed. Make sure the print bed is clean, as the front surface will be visible. Any residue or old glue may affect the appearance.

You will need four magnets for this project. A link is included below, but you can source them from anywhere. I’ve found that magnets from Makers Supply Store tend to be stronger than those from other random sellers.

If the magnets are a bit loose, a small drop of glue is recommended—just be careful not to spill excess glue.

Printing Tips:

• Allow the print to fully cool before removing it from the print bed.
• If removed while still hot, the frame may bend. If this happens, reheat the print bed to printing temperature, place the frame on it, and reshape it.

If you encounter any issues or have ideas for improvements, feel free to leave a comment. Thank you!