A1 Mini Tapo Camera Mount and Spool Holder C211

This is a version of my A1 Tapo camera mount that has been re designed to fit the A1 Mini.

From a search it should fit a variety of cameras as they use the same mount: TC70/C200/C210/C211/C220/C225, but check yourself before hand to be sure.

In addition to the Tapo mount, there is a Hex slot on the top that you can print plate 2 and have a top mounted filament spool holder to integrate with this.

The keyed connector on the arm is pretty snug so needs a good push to slide in but it will go in!

I would use a dab of CA glue on the arm connection and also the hex mount hole just to stop it going anywhere.

To fit you will need to remove the 3 small screws in the top and the 1 longer one in the front, remove the grey piece and the white plate which sits under that, then place this new one on top and re install the screws, it is a direct replacement for the top cap.

Included an additional print profile if you also have an A1 so you can print it in one piece, I could not get it to fit in 1 piece on the mini unfortunately.

In your camera app just flip the image in the settings, you get a bit of vibration visible in the camera but nothing that hinders the view.

Use manual printed supports included in the profiles, the PLA one has 30% infill for strength, the PETG has 20% which should be enough.

Feedback, comments, reviews all welcome, if you think I can improve or change it let me know will give it a go!

See here for the A1 version: https://makerworld.com/en/models/1051409