U2 Dragonlady

This is the U2 Dragonlady spy plane. I added lots of supports and this model printed out real clean. Also has a printable stand. Plane is 20% infill, stand is 20%. Both models are .2mm and i used brim to ensure bed adhesion throughout the print. 2 wall loops.

Medium Plane model Size:

Plane is 7.43" inch / 188.960mm Nose to Tail and 12.287" inch / 312.113mm Wing to Wing.

Large Plane Model Size: 400mm Wing to Wing.  H2 Printers

Plane is 9.5" inch / 240mm Nose to Tail and 15.750" inch / 400mm Wing to Wing.

Updates:

I have updated the model and this should of fixed the R/H pod issue. I have printed this out 3 times to test this and i had no issues, so hopefully you don't as well. The stand was updated to be flat and not pointed. Sized to each model.

Helpful hints:

Please choose the correct size stand for the correct model size.

Removal of the support materials. Don't be in a hurry to remove supports take your time. First i remove model from build plate. Than start at the tail of the model. Than the wing supports from the wing tip to the pods. Rocking back and forth should loosen the supports. The center supports should come off very easy. Than finish the supports from pod to center body.