New York City Manhattan (Large 8x10)

3D miniature of Midtown Manhattan!

 

Model spans from the East River to the Hudson river & 25th St. to 60th St.

 

 

Check out my collection of other Large miniature cities: https://makerworld.com/en/u/1935755220/collections/468505

 

New York City miniatures collection: https://makerworld.com/en/u/1935755220/collections/177621

 

 

This model was designed to be printed with a 0.4mm nozzle and 0.16mm layer heights. 

Try using a 0.2mm nozzle (0.08mm layer heights) or scaling up for even finer detail!

 

Note: If roads or other small details disappear after slicing, try lowering the extrusion/line width of external perimeters (outer walls) closer to 0.4mm OR use Arachne walls.

 

Framing Details

 

This model measures almost exactly 7.5x9.5in (241.32mm X 191.08mm) and should fit most 8x10 frames (assuming frame lip/overlap is around a half-inch). Feel free to change the scale/size of the model(s) to meet your needs.

 

Personally I use these cheap wooden frames from Amazon: https://www.amazon.com/dp/B08XVP48KQ

And blue printer paper: https://www.amazon.com/dp/B00006IDQT

 

I also included a large printable frame (w/ 1mm water plate) designed to fit my large miniature cities.

 

Note: This is a “large” miniature and will not fit the smaller ~5x7inch printable frame included with the other miniature cities!

 

MembershipBecome a Subscriber to obtain a Commercial License and sell physical prints of my models! License is valid as long as the subscription is active.