NFC Tag Key chain

This is a very Fancy (in my opinion) little Keychain dongle that holds an NFC Tag on the inside to store information Like a Phone number if Found or could just store the link to a Certain Music Video. Whatever floats your boat.

These are designed for a very fancy Upcoming Project where I am still waiting on some parts.

How does it Work?

Simple First step is to select the filament you want, load it and print it. 

The second step is to sand the logosurface of the NFC tag just a bit for better adhesion. 

Last step is simple when the printer pauses Lay the NFC tag on the inside (remove the tape on the back). Slow your printer down to 50 % speed and ensure the NFC tag sits flat inside of the hole. 

Step four resume the print and wait until done

What build plate should I use ?

I recommend The Smooth PEI Plate because it gives the best finish. all others work fine as well but i would not recommend the supertrack plate, but if you want to use this plate remember to have patients and heat it up to 55 C to make removal a bit easier.

If you have more questions, ask them in the Comments. I am always happy to help :)