Can dispenser for A1 mini

Boost MeHey, just a thought, but why not use your boost before it expires?
I would be delighted ;-)

Can dispenser for A1 mini

 

I was looking for a can dispenser for my A1 mini, but couldn't find one, so I made my own. I had some cheap filament lying around, so it was the perfect opportunity to use it. I hope it works as well for you as it did for me.

This can dispenser can hold up to 8 cans flush (ø7cm h11cm). Or even more when you fill up the top. It's super handy because you can always grab the oldest can from the bottom, so you're always moving your inventory around.
 

I added another print profile that offers a variety of screw lengths for an optimal fit. Select the screw size that best fits your cans.

 

I cut the screws that hold the two sides together in half to make it faster and easier to print.

If you have cans of different lengths, just change the screws. But if you have cans that are larger in diameter than the 7cm, you are out of luck, they will not fit in there.

 

Check out my larger version of this dispenser, which can hold up to 16 cans here.

 

Assembly is simple:

 

Use the test profile first to see if you can print the screw and thread so you can adjust the settings accordingly.

1. Print all five plates
2. Click the two sections of each side into place.

3. Use the four half-screws to fasten the two sides of the panels together.

   (Do not glue the screws together or you will be screwed!)

4. Fill the organizer with cans as desired.

 

Dimensions:

 

height 18cm

depth 35

The width depends on the size of the screws you choose.