Shaft grip for racheting screwdriver from Action

This grip is made to make it easier to use the ratcheting screwdriver by turning the shaft separately from the handle.

It is a press fit on the ratcheting screwdriver from the Action stores (shaft diameter of 7.3mm). The part can be scaled in the slicer to fit on basically any model.

I printed in PLA and for easier assembly i put the shaft in the freezer for 10-15 minutes. Even then it is a tight fit but with a few gentle hits from a hammer it goes on. It has to be this tight to keep it from slipping on the shaft.

Some extra info on the screwdriver: as the grip clearly won't fit over the wider end with the hex socket, you need to take the handle off. This model fortunately attaches its shaft with a common square socket which makes this very easy.

Keep this in mind if you use the part on another model as I'm not sure how common a detachable shaft is on these kind of screwdrivers.