90° Bent Corner Piece for Corner Wall Cable Duct

90 degree bent corner piece for my other model “Corner Wall Cable Duct”, to use at the end of the corner wall, when it hits the ceiling or another obstacle, allowing more cable ducts to continue in any of the two perpendicular directions. It is fully compatible and intended to be used along the other model referenced. The main print profile contains 4 copies of the corner piece that fit in the A1 mini too (you can exclude some of them using the app if you don't need 4 pieces). Different print profiles  are also included with covers of lengths that correspond to the ones on the original model, with the difference that they have an extra 1cm to be able to slide them also into the 1cm body piece that comes out of each of the 2 sides of the corner piece (see photos). Keep in mind that, as with the corner piece, you can exclude any copies you don't need from any of the profiles.

Print Profiles:

Not Compatible with A1 mini:

• 4x21cm (for the 20cm body)
• 4x18.5cm (for the 17.5cm body)

Compatible with A1 mini:

• 1x18.5cm (for the 17.5cm body)
• 3x16cm (for the 15cm body)
• 3x13.5cm (for the 12.5cm body)
• 4x11cm (for the 10cm body)
• 6x8.5cm (for the 7.5cm body)
• 9x6cm (for the 5cm body)
• 4 x Corner Piece