Bullet for My Valentine - The Poison HueForge

You can swap the green for red though I have not tried. results may vary depending on transmission distance. 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

The Model is 230x230mm in size
You may print at higher layer heights below the Min Depth of 0.64mm
The Max Depth is 2.6mm and the Actual Depth is 1.4mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA BambuLab Basic BambuLab Green Transmission Distance: 2.4
    PLA BambuLab Basic Jade White Transmission Distance: 6.1
This print uses 3 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.72mm) swap to BambuLab Green
    At layer #10 (0.96mm) swap to Jade White for the rest.