Balloon Car

Overview

This is a print-in-place balloon powered car that prints in about 60 minutes with multicolor and 40 minutes in single color. Run on smooth surfaces.

• No assembly required
• Use with a 5 inch balloon (small kind)

Also check out the standard version > LINK

Tips for Successful Race!

• Print at normal speeds
• Ensure filament is dry to maintain good wheel spin and tolerances
• Balloon must stay upright
• Do not overinflate balloon – 50 to 75% inflation is ideal to keep balloon upright and avoid dragging
• Install balloon and then inflate by blowing through nozzle
• Seal nozzle with finger until ready to race!
• Run on a flat & smooth surface

Profiles

• R01 - Initial release
• R02 - Added 1mm ground clearance
• R02A - Single color variant of R02