Disneyland castle - HueForge

I just made a 5-color Hueforge for my little daughters who love Disneyland and even after countless trips, want to go there again!

The model is printed with 5 colors. If you are using AMS, then just load first four colors and then you can easily swap the black with white anytime after the 7th layer is finished, but before the 19th layer starts.

About the HueForge:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200.x160mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.7mm and the Actual Depth is 2.2mm

This print uses 5 unique filaments

Swap Instructions (the color changes are already incorporated in the model):
    Start with Black
    At layer #7 (0.64mm) swap to Pure Cyan
    At layer #11 (0.96mm) swap to Yellow
    At layer #17 (1.44mm) swap to Red
    At layer #19 (1.6mm) swap to Jade White for the rest.

I have added a pause in the print so that you can swap first color with the last one in your AMS, if you have.