Yarn Ball hoodie drawstring beads

Crochet anyone?  Here is a must have for that favorite crochet enthusiast!.  I designed this with a 7mm hole through to allow for large drawstrings to get through.  It's a quick (45 Min.) print and comes out fairly clean with no support.  If you look at the comparison picture with the white and yellow ball you can see the difference on the bottoms.  The white was printed with support and the yellow was printed without.  There was a little post print clean up on the yellow to remove the loose strands at the bottom.  But I think the fuzzy skin turned out good.  

Have a Ball ;)