Sun Sword - Curse of Strahd

After searching around for a few hours, I found this model of the Sun Sword from Curse of Strahd from /u/Akoloutheo77 on reddit. Without a doubt the best looking model I could find.

• Added a model of a rod to combine the pieces together.
  • Optionally, you can buy a 200mm X 10mm Steel hex rod (I got mine from AliExpress for ~$8 total). This gives the sword a good heft, and helps balance it in the hand.
• Added some jewel models to go into the Pommel and main “guard”.

For the guard, I recommend just printing it as slowly as possible. There's a lot of small parts (text, the sharper points on the lower “quills”, etc.) and it comes out great at 50% speed. You might be able to tune your settings to get it a bit cleaner, but I was more than satisfied with just lowering the speed.