Giant Darts Holder - Wall Mount

Wall mounted darts holder for giant darts. This holder was made to hold the giant darts by TheBavarianModelMaker - https://makerworld.com/en/models/932814-giant-dart#profileId-896985.

I made the holes for the dart tips a tighter fit as I didn't want a lot of movement when the darts are installed. You may need to use a sharp drill bit to completely clean out the supports from the holes & round the holes if they don't print perfectly circular. The results will depend on your printer. I used a 10.5mm drill bit & the points fit in nicely. DON'T use the drill bit powered only use with hand strength or you risk damaging the model. 

I used 2x10.5mm washer head screws to fasten to the wall