Star Trek Combadge Set - Simple Lapel Pins

A set of remixed Star Trek Com Badges. Remixed to fit a backplate that takes a lapel pin as well as modified where needed to fit the backplate width wise.

2025-03-12 - UPDATE - I have added the backplates to the profile and split it into 3 plates to make it easier for anyone who has already printed the pins. Sorry for the mistake.

1. Full set of pins with backplates
2. Just the pins
3. Just the backplates

Perfect as a badge, shirt pin, backpack pin, or really pin them to anything you feel like.

1. Print Pin and Pin Backplate
2. Add hardware pin to Backplate
3. Clip Pin to Backplate.
4. Done.

*There is a notch in the backing so you can change them by popping the pieces back apart.

Part of the SimplePin Collection - https://makerworld.com/en/collections/4330701

Simple Pin Details and Information

SimplePin is a 2 piece system for making lapel pins.

SimplePins consist of a few parts:

1. Pin
2. Pin Backplate
3. Hardware Pin (non 3d)
4. Hardware Pin Back (non 3d)

Pin

• the part with the logo, image, text, etc
• 3 clip insets for attaching to Backplate securely
• removable from backplate with notch and a bit of force
  • may need a small flathead screwdriver

Pin Backplate

• notch and hole for butterfly pin and nub that most butterfly pins have
  • the pin hole and nub hole are made very small to help hold in place without glue

Hardware Parts

1. Butterfly Cluth Pins with Pin Back
   1. The cutout fits 4.5mm diameter pinheads. I have purchased those labelled as 4mm but even they were 4.4mm diameter.
   2. If you get pinheads that are smaller the friction of the pin should keep in place but a touch of glue will do the trick if not.
   3. If you have pinheads larger than 4.5mm they will still work just wont fit in the inset fully.

You can buy them on Amazon for around 10 cents each and even cheaper on Aliexpress

Adding pin to Backplate