HueForge - Levi Ackerman

Project: HueForge - Levi Ackerman
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 131.08x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
    PLA BambuLab Matte Black Transmission Distance: 0.6
    PLA BambuLab Matte Pine Green Transmission Distance: 1
    PLA BambuLab Matte Ash Gray Transmission Distance: 1.5
    PLA BambuLab Matte Ivory White Transmission Distance: 3.5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #4 (0.79mm) swap to Pine Green

Border Only Colors from here until the end.
    At layer #6 (1.06mm) swap to Ash Gray

This slider is set higher than the mesh depth.  It is not affecting your final mesh.  Consider removing it.
    At layer #12 (1.33mm) swap to Ivory White for the rest.