Ariel and PrinceEric (The Little Mermaid) Hueforge

Not enough Ariel on here so I thought I'd spice it up a bit!  I used acrylic markers and a fine point Sharpie as shown in the picture to color in some parts. Her blue bow doesn't show up, so that will have to be colored/painted.  Highly recommend painting/outlining certain parts to really make it pop!  

Project: ariel1.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x150mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA BambuLab Basic Red Transmission Distance: 4
    PLA BambuLab Basic Blue Transmission Distance: 4
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Red
    At layer #13 (1.12mm) swap to Blue
    At layer #20 (1.68mm) swap to Jade White for the rest.