N3D Pokeball Stand - Healing / Charging Station

N3D Poke ball Stand - Healing / Charging Station

As in the game I have created a large print based on the healing station and it can hold 6 different N3D Poke balls on it. The Character balls may fit but not all models will due to wings, tails etc.

Please be aware that this is a big print and uses just over 700g of Filament. When doing the the stations larger pieces that are marked grey I suggest using a new role of filament just in case you have two of the same colour but there is a slight difference in the colour between the rolls. This happened in my test print that is in the photos. 

There are 5 Plates in this model and the colours used in the test print are listed below.

Dimensions - 270mm (W) x 344mm (D) x 120mm (H) 

The print in the photos used the following filament;

Bambu Lab - Matte - Scarlet Red

Bambu Lab - Matte - Ivory White

Bambu Lab - Matte - Basic Light Grey

There has been a few chats had about this in different groups so thought I would create one and have obtained N3D permission to publish it and refer to his models.

N3D has also got an Patreon page where you can find a larger variety of Pokemon Character balls available.

Patreon
Facebook

UPDATES

V2 - Has got an additional plate where the stands within the Healing Station sit 1 cm higher. Only one plate needs to be printed.