March 15, 2025
Description
News [22.04.2025]
I have added two new print profiles!
Both feature a reinforced frame to support the weak point at the ammo inlet.
The firing range was increased too.
Difference: The “recommended” version features increased tolerances of 0.2mm for easier printing and a reduced chance of parts fusing together, which allows them to move much smoother too!
Layer height: 0.2mm, or finer (haven't tried taller than 0.2mm)
Perimeters: 3+
Material: PLA Basic (not matte or silk!!!), PETG, ABS, ASA, etc.
Supports: Not required!
Please clean you build plate, to ensure best first layer adhesion!
Note: Your printer should be able to handle 0.2mm tolerances fine. Otherwise parts might fuse together or have to much friction when assembled!
Warning
This 3D model of a BB pistol is not a toy. While it may look like one, it can be potentially lethal if misused.
I assume no liability or responsibility for any damage, injury, or legal consequences resulting from the use, reproduction, or modification of this model.
Use responsibly and ensure compliance with all applicable laws and safety guidelines.
When the gun is not in use, please always remove the magazine to keep the bb release from wearing out. After some time, it will probably wear out anyway. If so, please try bending the spring back into place with help of light heat (for example a lighter).
Please also use this model with more caution, if no magazine is inserted, due to the rather thin and fragile section that would be in contact with the magazine.
That's basically it, so have fun and enjoy!
License:
Standard Digital File License
PeliX3D
