Elegant Eggs 4 and 5

A while back I came across the designs of Dazus on Thingiverse, and I really loved their ornaments with the sweeping curves. I wanted to try my hand at designing my own in the same style, and this is one of the results.  I used Make My Vase to create the initial models, and combined and edited them in Bambu Studio. One of them is similar to my Egg 2, but a little taller ridges.

The top is best printed with a tree support inside to support the top. It will print ok without the support, but the inside top was a bit ugly. This is best printed slowly, especially the lower half as there is an area where the angle at the bottom does not come out clean if printed too quickly. I would recommend using the speed settings I provided plus reduce printing speed to 50% on the printer.

Powered by MakerWorld-Make My Vase (https://makerworld.com/makerlab/makeMyVase)