Kitchen Cabinet Spray Bottle Holder

Convenient hanger for spray bottles for the back of your kitchen cabinet door!

Simple quick print with minimal waste.

 

I recommend using PETG to get good strength for the mounts and the dowels.

 

Assembly instructions:

• All parts are printed on a single print bed (For P1 and X1)
• The dowel prints as an upper half and a lower half
• Assemble the upper half of the dowel to the lower half and insert through one of the hanger holes 
• This fit is intended to be tight for strength. Insert both dowel halves the same time and push all the way through until it hits the stopper at the end of the rod
• Insert the second hanger at the other end of the rod and slide just past the stepped portion at the end of the rod
• Insert the end tap on the stepped end of the rod
• Slide the second hanger to the end of the rod, touching the end cap
• ROTATE THE ROD TO ORIENT THE ROD SUCH THAT THE SEAM BETWEEN THE “UPPER” AND “LOWER” ROD IS ORIENTED VERTICALLY - THE SEAM SERVES TO PROVIDE ADDITIONAL FLEXURAL STRENGTH TO SUPPORT WEIGHT.

Let me know if you have any questions or suggestions

Boost Me