Roman Battle Hueforge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 225x156.04mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA PolyLite Brown Transmission Distance: 0.8
    PLA BambuLab Basic Blue Gray Transmission Distance: 3
    PLA BambuLab Matte Dark Red Transmission Distance: 1.5
    PLA Overture Yellow Transmission Distance: 9.7
    PLA SILLK Eryone Silk Gold Transmission Distance: 5
    PLA SILK Eryone Silver Transmission Distance: 5
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 8 unique filaments

    Start with Black
    At layer #10 (0.88mm) swap to Brown
    At layer #12 (1.04mm) swap to Blue Gray
    At layer #15 (1.28mm) swap to Dark Red
    At layer #18 (1.52mm) swap to Yellow
    At layer #19 (1.6mm) swap to Silk Gold
    At layer #21 (1.76mm) swap to Silver
    At layer #25 (2.08mm) swap to Jade White for the rest.

This is my next hueforge creation. One of my best so far.

It perfectly shows all the detail that you would want in a battle like this

As always it is a good thickness and not to flimsy

Hope you all like it