Nazgul Figure – Lord of the Rings

Boost Methank you for your support

https://ko-fi.com/drakeforge3d  If you like my work and want to support me, I appreciate any support.

 

Nazgul

A mysterious Nazgul emerges from the shadows, gripping its ghostly sword with an eerie presence. This miniature captures the essence of the Ringwraiths from The Lord of the Rings, evoking fear and fascination in equal measure.

 

 

 

Recommendations: In case of a problem with damage to the supports, I recommend reducing the printing speed of the supports by 30-50% and the travel speed to 400mm/s. When removing the supports, I recommend first cutting off the pieces right next to the character, but not removing them, just cutting them off. Remove the remaining larger pieces and only then detach the remaining smaller pieces. This reduces the risk of damaging delicate elements.

 

 

• Please note that if you use a different filament than the recommended one, the effect may be different from my print. For example, printing in silk PLA will look better but the supports and the print itself will be more brittle and less durable.

   

•  

  Recommendations:

• 
   
• 0.08-0.16. In the event of changing the original height, the height of the supports should be changed.
   

• PLA+HS, PLA+, PLA, PLA silk Recommended materials are listed in order from best to good.

   

• Clean the plate thoroughly before printing.
  Make sure the filament is dry and free from dirt. This can damage the print or weaken the support