Ikea Fniss -> Hydroponic Tower

This model enables you to use your ikea fniss trashcan as a water reservoir for your hydroponic tower.

The Ikea Fniss trashcan is quiet cheap (2.50€ in Germany) so its a good option especially for smaller towers.

I designed a normal lid and one with a hole for cable and refill. There is a plug to close the hole too.

This design uses the Module_Adapter_Custom.stl from the original design as connector to screw your tower on.

I just glued everything together. The 4 quarters can be screwed together using m3 screws.

Adjust to your needs. I provide the onshape project:  Link

Guide

Print

• 3 of “Fniss Lid quarter part” - from this printable page
• 1 of “Fniss Lid quarter Part with hole” - from this printable page
• 1 "Fniss Lid hole plug" - from this printable page
• 1 “Module_Adapter_Custom.stl” - from the other printable page

Asseble

1. einter (or both) glue and screw all 4 lid plates together
2. after it dried, glue the “Module_Adapter_Custom” to your lid. This makes the whole connection even stronger
3. Just snap the whole thing onto your fliss trashcan

Leave a comment for feedback, a make and like :)

Have fun