WTMicro Willys Interior

I made an interior for the WTMicro Willy's body. Has a dash, a gauge circle, steering wheel, and an interface to run a minifigure torso as a driver. 

Designed to be placed where you want installed, and drill small holes in the rear of the cab to fasten with a threaded fastener. The back of the model is flat so there is some wiggle room in placement and room to drill where needed. depending on install height, might run into issues with accessories on the minifigure's head.  I used a 1.3mmm-ish hole and stock sck24 m1.4 screws to fasten to the cab, screws visible in photos. Be careful not to drill through the front of the seat if you don't want holes there. 

May not work with all electronics, if mounted high enough it seems to clear my micro komodo brushelss setup but not my mini komodo pancake. May be able to mod the front to make room for the pancake style motors however. 

Please be careful removing supports around the steering wheel, it's robust but can easily snap off if pressure is applied, unfortunately supports are required to get the steering wheel to print nicely. 

Tried to make this fit as easily as possible within the confines of the wtmicro design, which wasn't the easiest to do with very little to interface on in the body itself, but I really wanted an interior in this thing… hope it works for you too!