Electrical box NEMA 5-15R outlet; IEC C13 input

STEP files included!

 

Global Industries make awesome desks but the power cord is 60$CAD. 🤑 So I decided to create my own with a switch, fuse and can be disconnected. I made two versions, one with snap fit and one with screws on wings. I recommend the screws if you can. The snap fit one is much thinner though.

 

Hardware

1. Standard NEMA 5-15R outlet. About 2$CAD.
2. C13 socket with 10A fuse and switch from AliExpress. About 2.50$CAD.
3. A short run of 14 AWG. A few cents.
4. M4 inserts and screws (I didn't have #8-32 inserts on hand) OD is 5.8mm. A few cents.
5. A NEMA 5-15P to IEC C13 120V cable. I salvaged one from a dead computer.
6. Solder
7. Heat shrinks

I personally printed in ABS but anything would do. The end result is very clean. STEP is included to feel free to adapt as needed.

Boost MeI make niche utility things that do not get a lot of reach but still take a huge amount of time to prototype. Boost are greatly appreciated!

I AM NOT AN ELECTRICIAN. YOU ARE RESPONSIBLE FOR YOUR ACT. This electrical box is not certified in any way, and it's use is entirely at the user's own risk. The author assumes no responsibility for its usage. It is strongly recommended to include an automatic disconnect system, such as a circuit breaker or ground fault interrupter (GFCI), to protect against potential short circuits.