Skadis Side-Mount Cable Clip -No Loss of Pegspace!

Keep your workspace neat and your cables in check with this custom-designed Skådis Side-Mount Cable Clip! Designed specifically for the IKEA Skådis pegboard system, this clever little clip uses the existing peg holes for a snug, secure fit — no glue, screws, or mods required.

What makes it special? The clip holds your cable to the side of the pegboard slot, keeping wires easily accessible but out of the way of tools or bins — and here's the best part: the hole beneath the clip is still partially usable. If you slightly modify a peg or accessory (like trimming the back prong), you can reclaim that peg hole, allowing you to maximize space on your board even further.

✅ Tool-free installation
✅ Clean, low-profile design
✅ Smart side-mount keeps peg holes available
✅ Works great for cable management in tight spaces
✅ Designed for 3D printing with no supports

Perfect for routing USB, power, or charging cables along your Skådis board in a workshop, office, or streaming setup. Tidy up your cables without sacrificing valuable pegboard real estate!

Install by placing in on an angle with your wire secured in the wire slot.

The Cricut Autpress Mount seen in the photo can be found here: https://makerworld.com/en/models/1298583-cricut-autopress-control-pod-mount-for-ikea-skadis#profileId-1330470