bogg Style Tote Charms

These are great and easy to do charms for any bogg style tote.  The piece that goes through the hole is 17mm and the passthrough shaft is 7mm.  The “Post” is 25% gyroid infill.  The “Support” is 15% Lightning infill with 1 wall and 2 layers top and bottom.  These cylinder support leaves a slight gap between the flower base and itself.  This leaves a clean finish when you break it away.  There are 5 flower in this collection. (3) are 40mm and (2) are 50mm.  There are endless combinations available. 

Definitions:

Post - the piece that passes through the bag that the flower sits on top of.  Should be same material as the support.

Support - The donut that surrounds ONLY the post that is SLIGHTLY lower than the bottom layer of the flower.  Should be same material as the Post.

Base - the contrast layer that sits slightly above the Support.  Can be any color.

Layer # - Each numbered layer should be the same color.  You can select a group and change the color all at once by right clicking the selection and clicking Change Filament.

Flower 1 - 40mm

Diamond pedals with a circular base and domed middle.

Flower 2 - 40mm

(6) pedals on a base with a domed center.

Flower 3 - 40 mm

An artistic take on a flower using only circles on a base.

Flower 4 - 50mm

Multi-pedals with a domed center with NO BASE.  Use the parting tool to barely break away the tip of the pedal from the support.  There should not be a lot of movement here.  The the pedal TIP away from the support for each pedal, then press the post from the opposite side and the flower should release.  It is possible to pop off the pedals so you have to take care on this one.

Flower 5 - 50mm

A layered pedal on a base and a rounded center.  Designed by a 6 y.o. (Center Charm in pic)

REMOVING SUPPORT