Ikea Skadis Mount for HDD Clock

Ikea Skadis Mount for Hard Drive Clock designed by @Ken Mills 

https://makerworld.com/en/models/873387-hard-drive-clock#profileId-825696

This mount was designed by me to mount the above HDD Clock to an Ikea Skadis peg board. Mount screws into HDD Clock by existing holes in top or bottom of clock back. Mount doesn't obstruct any of the clock workings…. Adjusting time or replacing battery.

This mount was printed on my X1C in e-sun Black PLA+ & it's a perfect fit on the Skadis, not too tight not too loose. 

**Please don't give bad ratings if its not to your idea of a perfect fit as all printers print differently, use different filaments, are tuned differently & have different tolerances when printing, thats not my fault 🙂

A brim has also been added in the profile if you're concerned about bed adhesion. I didn't print with one because I don't have bed adhesion issues.

Enjoy & Thank you