Hueforge RICARD

Hueforge RICARD

There is a version with a hole and a version without a hole

The variation in colorimetry in the different photos is due to them being taken at different times of the day.

Boost MeBoost Me Please :p:d

Project: RICARD.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 176.87x245mm in size
You may print at higher layer heights below the Min Depth of 0.64mm
The Max Depth is 3.3mm and the Actual Depth is 3.4mm

 

Filaments Used:
    PLA BambuLab Matte Charcoal Transmission Distance: 0.6
    PLA Sunlu + Sky Blue Transmission Distance: 5.2
    PLA Sunlu + Green Transmission Distance: 3
    PLA BambuLab Basic Red Transmission Distance: 5
    PLA BambuLab Basic Yellow Transmission Distance: 5.5
    PLA Sunlu White Transmission Distance: 7

This print uses 6 unique filaments

 

Swap Instructions:
    Start with Charcoal
    At layer #8 (0.72mm) swap to Sky Blue
    At layer #14 (1.2mm) swap to Green
    At layer #18 (1.52mm) swap to Red
    At layer #25 (2.08mm) swap to Yellow
    At layer #32 (2.64mm) swap to White for the rest.

 

Please leave a comment and like if you like my Hueforge. Thank you very much.

Non-commercial !!!