Jet Engine Motorized stand with non-slip

I had made a stand;

The originally with Non-slip pads to display the CATIAV5FTW turbine.  

I noticed that 3d_printall made a motor adaptor named N20 Motor mount for Jet Engine (https://makerworld.com/en/models/157767-n20-motor-mount-for-jet-engine?from=search#profileId-206779) .  After finding motors and controllers online, it worked great.  Because of this mod, I had to design a new stand.  This print is a test bench look designed to look like a turbine test site set up.  There is mounting for the moto controller and tunnels to hide the wires.  I will post what I bought to make this motorize display come to life down below.  I made a guide attached on construction.

 

Note!!: lesson learned the hard way.  When i made the stationary turbine, no glue was needed.  If you make it a motorized turbine, you MUST use Locktite to ensure the screws and nuts used to put the model together don't vibrate off.  

 

Amazon parts list: Can be changed to other brands or models if needed.

DC Motor.  https://www.amazon.com/dp/B083GM3JV5?ref=ppx_pop_mob_ap_share

Speed Controller. https://www.amazon.com/dp/B08BJ4WQCV?ref=ppx_pop_mob_ap_share

Power Adapter. https://a.co/d/bmha5Fv

Wires. https://a.co/d/cXG1xsN

Boost MeIf you want to support an amateur designer.